Occasional Newsletter: 
KnivesAndKnifeMaking.com

Mosaic Pin #105 Full Bear 1cm Steel Knife Making Handle Scales Grips Hunting Knives

knife kits, knife kit, knives kits, kits, fathers day gift ideas Mosaic Pin #105 Full Bear 1cm Steel Knife Making Handle Scales Grips Hunting Knives

Mosaic Pin #105 Full Bear 1cm Steel Knife Making Handle Scales Grips Hunting Knives Mosaic Pin #105 Full Bear 1cm Steel Knife Making Handle Scales Grips Hunting Knives Mosaic Pin #105 Full Bear 1cm Steel Knife Making Handle Scales Grips Hunting Knives 
(click to zoom)


Model: D-MOSAIC-105

This product is for hunting.

This unique mosaic pin was hand-crafted by an expert. Add that extra bit of flair to your knife handle! This pin can be used for knife making, metal work, jewelry etc.

It can be used as a solid pin or sliced into thin pieces for inlays. The pattern exists along the entire pin length.

Important Instructions:
  • This pin is made with O-1 steel, which is a high carbon steel. Therefore, once your knife handle has been built, it is important to keep the surfaces of the mosaic pin protected with clear varnish/lacquer. If there is no varnish or lacquer, then the O-1 steel may rust.
  • This pin requires a hole of 1cm to be drilled into the handle of your knife. You simply need to use drill bits intended for drilling metal, which are capable of drilling through the steel type of your blade (i.e. hardened 1095 high carbon steel, D-2, stainless, etc).
  • Do not expose to excessive heat when cutting the pins (it will become damaged over 95 degrees celsius). Do not polish them too much.
  • Use only sandpaper for polishing. Use 1200 grit sandpaper for final polishing.
  • And last, use lacquer or oil on the surface of the pin to protect it from the elements.
Specifications:
  • This pin is made from copper.
  • Outside Diameter: 1cm (equal to 10mm) (approximately 25/64 inches)
  • Length: 10cm (4 inches)
  • The center of the mosaic pin is filled with black epoxy resin.
Our mosaic pins have been vacuum-pumped to remove air bubbles. The resin is pulled in with a high-end vacuum, which pulls the glue down, and removes any small bubbles. The pins are cured afterward and lastly polished and burrs removed.

This makes a great holiday gift, Christmas present, gift for your father, father's day gift, surprise for your husband, mens, guys, men, mens gift. It is great for hunting, skinning, camping, hobbyists, do it yourself, diy, outdoors men.


Item not in stock.





Customers who bought this item also bought the following items:
[no image]
High Carbon 1095 Steel Tracker Knife Blank Blade Hunting Skinning 1095HC New

 $35.15 

[no image]
Hunting Damascus Blank Making Steel Blade Layers Knife Raindrop Knives Blade Billet Bar

 $41.45 

[no image]
1095 High Carbon Steel Tracker Knife Blank Blade Hunting Skinning Skinner 1095HC Black Powder Coated

 $36.15 

[no image]
Hunting Raindrop Damascus Tracker Large High Carbon Steel Blank Blade Knives Knife Making Blanks

 $43.45 







KnivesAndKnifeMaking.com © 2012-2017